Cleaning the condensate drain system

The condensate drain system traps dust and dirt. Clean the drain system once a year. Shut off the rocker switch and unplug the unit.Remove the duct on the evaporator inlet.Inspect the drain pan under the coil.If drain pan appears soiled, pour some hot water mixed with liquid bleach (diluted solution) along the length of the

Continue Reading

Cleaning the condenser inlet filter

The condenser coil is provided with a reusable, washable air filter. The filter protects the coil from becoming coated or plugged by dust. Frequency of cleaning the filters is based on the amount of dust or dirt generated in the cellar or basement. Remove the duct collar on the intake end of the unit. (Optional)Remove the filter

Continue Reading

Glossary Sections

For your reference, the following are commonly used terms in our installation guides.  Ambient AirThe surrounding area outside the cellar such as a room, basement, garage or outdoors.BTU/HBritish Thermal Unit per Hour is a unit of heat measurement. For example, one ton of cooling equals 12,000 BTU/HCECertificate of European conformityCFMCubic feet per minute. A unit

Continue Reading

How to adjust the temperature setpoint

Press and release the UP arrow key. On the left side of the screen the temperature set point number will start blinking.Press the UP or DOWN arrow key to adjust to your desired temperature.Once the screen defaults back to the temperature and humidity display, check to be sure the system is set in auto mode. In auto

Continue Reading

How to adjust humidity setpoint

NOTE: Setting #6: "Add or remove a humidifier" must be set to 1 or 2 in order to change the humidity set point. Press and release the UP arrow key. On the left side of the screen the temperature set point number will start blinking. Press the mode button once and the Humidity set point

Continue Reading

How to select Cooling, Heating or Auto modes

Press and release the settings key (gears button). On the left side of the screen you will see a snow flake or flame or both at the same time .Press and release the settings key again to toggle between:Snowflake = cooling modeFlame = heating modeSnowflake and flame = auto mode A flashing snowflake means that the

Continue Reading

Resetting the High Pressure Switch

Every Wine Guardian unit has a manual reset high pressure switch in the refrigeration system. This switch shuts the compressor and condenser down if the head pressure in the system is too high. It is intended to protect the compressor. Restricted airflow through the condenser is the most common reason for the pressure becoming too

Continue Reading

Humidifier Datasheet

Wine Guardian® humidifiers are uniquely designed to deliver superior performance and reliability, ensuring the proper conditions for your wine collection and cellar. Our humidifiers regulate and control humidity while offering the versatility to be used with any brand of wine cooling system. Humidifier features Monitors and controls humidity in the wine cellarEvaporative drip pad system

Continue Reading